SOLID STATE ELECTRIC SPREADER CONTROL – SSC240
The SSC240 is a fully solid state controller that incorporates maximum functionality with ease of operation in a compact, reliable package. This controller is designed for the new age of spreading using low voltage DC motor power. It’s flexible, quiet and powerful.
Maximum Current Capacity: 240 AMPS @ 12VDC (120 AMPS @ 12VDC each circuit).
The SSC240 may be used to drive both single and dual motor spreading equipment with no
On Board Diagnostics: The SSC240 comes equipped with diagnostic indicators – both on the power module located on the spreader and on the operator interface. The On board diagnostics promote quick and easy trouble shooting in the field and help to eliminate poor spreading performance by alerting the operator to partial or fully obstructed chain and spinner conditions.
Easy to use Operator Interface: The operator interface of the SSC240 is intuitive and easy to operate for almost any skill level, in either day or night. Easy to read electronic graphics clearly show chain and spinner speed at any time and make on the go adjustments a snap. No more guessing how much material is being applied or if the machine is working properly.
Oversize buttons allow the operator to synchronize chain and spinner speeds with one touch and a blast feature brings both chain and spinner speed to maximum for trouble spots.
GPS Speed Synchronization: Contractor size spreaders can now enjoy the features and material savings of larger commercial spreaders with GPS speed synchronization. The SSC240 is fully GPS enabled which allows you to utilize variable speed rates. No connection to the speed sensor on the vehicle is necessary. Enjoy material savings and accurate spreading while eliminating spreading at stops and road spreading between jobs with the low and high speed limits. When the vehicle stops the spreader stops and when the vehicle reaches the high limit (road travel) the system disables the spreader until the operator resets.
Stand Alone System: The SSC240 operates as a stand-alone system on electric spreaders if configured to designed spec. Using an auxiliary battery on the spreader, the system requires only a connection to an RV type trailer plug on the vehicle. No direct connections to the battery are necessary, eliminating potential warranty issues with high amp
draw on the vehicle system.
Complete Kit: The SSC240 is supplied as a complete kit for use as a standalone system including operator interface, motor control module, shaft speed sensors with brackets, battery box, hardware, all wiring, motor cables and RV plug.