Custom Electronics

The Rowe IPDM™ Power Distribution Module expands CAN bus and Bluetooth control networks by replacing relays and fuses with a more reliable solid-state circuit board design. This design can directly drive any application to where a conventional fuse and or relay may be compatible.


Each of the 9 outputs can switch or control up to 13 amps in 1/2-amp increments and feature built in over-current detection and automatic shut down protection.  Outputs can be bridged for higher loads.


The 9 inputs monitor switched battery, ground and floating inputs.

Wiring and troubleshooting will be greatly reduced by installing the IPDM closer to your end device.


The I/O is fully multiplexed, using CAN bus or Bluetooth, which allows user to simplify wiring designs for ease of installation.


For applications not requiring CAN bus, inputs can be directly wired to the IPDM to trigger an array of outputs.


The enclosure is fully sealed to conform to the IP69K standard.

Available summer 2020.


PLEASE CALL (515) 981-5504

  • CAD file - available upon request

  • STP file - available upon request

  • DWG file - available upon request

  • PDF file - coming soon




339 Hakes Dr. Norwalk, IA 50211

created by Eunoia Creative Co